Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
1. Place PLAYFIELD #3, with field markings facing down, onto the ledge of the SIDE PANELS #1.
Note: The table is assembled upside down.
2. Attach one END PANEL #2 to each end of the table with 5/16" BOLT #10 and 5/16" FLAT WASHER #8.
Note: DO NOT over tighten bolts. In this step, loosely tighten just until sides touch.
3. Attach PLAYFIELD to table with 1" FLAT SCREWS #13 around inside edge using pre-drill holes. Note: ALWAYS
use pre-drilled holes. If not, permanent damage can be done to table. A flashlight can be helpful in aligning holes.
It may be helpful to have a second person push on the opposite side, as you attach Playfield, in order to square
up surface. Make sure End Panels fit snuggly against Side Panels before screwing down Playfield.
4. Insert the APRON CORNERS #35 onto the SIDE PANELS #1 and END PANELS #2 on the four corners.
Note: Make sure inside screw holes are positioned at top.
5. Tighten 5/16" BOLTS #10, loosely tightened in Step 2, on both sides.
#10
#1
#3
Field corners are
intentionally tapered
down for play.
#2
#8
#35
#13
#8
#10
Playfield
Side
Panel
#1
4
Publicité
