inXtron SK-3500 Super-S3 Mode D'emploi page 4

SK-3500
2 System Set Up
2.1 Hard Drive Assembly
Your unit may come with a pre-installed hard drive. Before opening your enclosure, please read
the warranty carefully, as this could void it. Be careful not to damage any components when
installing the hard drive!
1. Remove the four screws located at the bottom of the case and pull out the HDD chassis
from the enclosure.
2. Install the hard drive and connect both the power and the SATA cable. Mount the drive with
the four screws from the bottom.
3. Carefully slide the assembled drive back into the enclosure and do so as not to damage
any of the components.
[3]
System Set Up