Publicité
Les langues disponibles
Les langues disponibles
GB)
Auto switching on when movement of a heat source, such as people or animals are detected in the
-
dark area
Delay time is 30 seconds
-
Detection area must be dark as the LED night light with CDS sensor smartly
-
control the PIR sensor not to be activated during daytime or at bright area.
The sensor light will sense movement within 3 meters distance and within
-
100 degree horizontally and 50 degree vertically
Warm up time is 1 minute; sensor night light will only function after switch
-
on for 1 minute
Ideal for indoor decoration and uses in anywhere at home, stairway, corridor,
-
entrances, basement, kitchen, bathroom, bedroom ect.
Operation
1. Plug in the light to any A/C outlet
2. Set the mode switch to "Auto", the light will warm up itself with light on for 1 minute, and then light
off for sensor ready.
3. The CDS sensor will trigger the front light on continuously in dark area; and off at dawn.
4. Turn mode switch to "ON" position for continuous (front and back) light on.
Attention:
Do not immerse the nightlight into water or use in wet condition.
-
Do not disassemble it by yourself
-
Beware of the electricity & electronics parts, it is not a toy.
-
Specification:
Power supply
Bulb (front light)
Bulb (back light)
LED sensing Lux
Size
Weight
Service
If you have any further questions about the product after reading this manual, please contact the Trebs
customer service: Phone: 0900-TREBSbv (0900-873 27 28), € 0.30 per minute.
CE
AC 220-240V / 50-60 Hz
1 x 0.06W LED
8 x 0.06W LED
< 10 Lux
57 (L) x 63 ( W) x 114 (H) mm
72 gr
Publicité
