Videotec UPTJBUL Manuel D'instructions page 5

6 Assembling and installing
The assembly and installation must be
performed only by skilled personnel.
6.1 Installation
6.1.2 Connections
Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
Open the watertight box, taking care not to damage
the seals.
Fig. 1
Connect the power supply cables to the electric
network, according to that indicated in the figure.
Use cables with section equal to at least 2mm² (AWG
14).
Line
Linea
a
Fig. 2
MNVKUPTJBUL_1420_EN
Line
Linea
a
6.1.3 Replacing the cable gland
Remove the cable gland highlighted to replace it with
the relevant fitting, taking care not to damage the
fixing nut.
Fig. 3 ULISSE line.
Fig. 4
ULISSE COMPACT line.
3