Threading The Tissue Or Fleece Web Into The Steep Bath; Cutting To Length With The Help Of The Analog Meter Counter - Vitrulan AQUA QUICK I Mode D'emploi

3.5 Threading the tissue or fleece web into the steep bath

Due to the shape of the steep bath, the tissue/fl eece can be moved under both steep baths without a problem. The device is equipped
with a stripper system. To thread in the tissue or fl eece web, the water skimming fl ap is folded down (= transport position). With the
help of the adjusting screws, the fl ap can be moved higher or lower, depending on how much water the adhesive applied to the rear
should receive.
Water skimming flap folded down. Water
skimming strip fixed in place to remove
excess adhesive.
Due to the stripping system, excess water is removed:
- defi ned water application for the complete activation of the adhesive
- formation of drops on the fl oor is prevented

3.6 Cutting to length with the help of the analog meter counter

The webs are drawn through the machine in
the required lengths and are placed together
in loops.
„Last section":
Pull the last section through the device 50 cm shorter and cut it off before the steep bath.
This prevents waste.
Once the tissue or fleece web is threaded
in place, the water skimming flap is flipped
upwards.
The web is cut off on the cutting edge on the front
of the steep bath. Only once the last web is run
through it is cut off directly in front of the meter
counter.
In operation mode, the water skimming flap
lies on the tissue or fleece web. Now the
adjusting screw can be used to make
individual settings. This can, for example, be
helpful in the following cases:
- extreme temperatures
- personal requirements
(e.g. difficulties in opening)
To correctly measure the
section, please set the
meter counter back to
zero after every cut.
13