Filling The Steep Bath; Assembly Of The Analog Meter Counter; Pulling The Tissue Or Fleece Web Into The Roller Device - Vitrulan AQUA QUICK I Mode D'emploi

GB

3.2 Filling the steep bath

Since the water temperature has an influence on the activation speed of the adhesive layer, the water temperature
should ideally lie between 10° and 25 °C.
- Lower temperatures lead to delayed activation behaviour of the adhesive coating = unnecessary waiting times.
- Higher temperatures reduce the storage/processing ability of the wet tissue webs.

3.3 Assembly of the analog meter counter

The analog meter counter has two spring
clips on the rear that are latched into the
front holding rod of the roller device.

3.4 Pulling the tissue or fleece web into the roller device

The tissue or fleece roll is placed on the roll-off rollers. When drawn in correctly, the tissue or fleece web will run under the front guide
roller and the holding axle of the meter counter. The adhesive side (= inside of the roller) points upwards! If required, set the adjusting
ring to the width of the tissue.
12
Minimum
The counter is set to zero by moving the
„lever" upwards.
Before filling, please
check that the drain
plug is firmly closed.
Put a bucket in place if
necessary, then fill the
steep bath with water.
Minimum level: Steep rollers must be
covered with water up to the upper
edge = approx. 15 litres.
The analog meter counter
is not water-resistant!
Its attachment to the
device is designed in such
a way that it folds down into the steep
bath when the lid is closed. That is why
you should always drain the water before
closing the device lid or remove the
analog meter counter!
Turn roll backwards by
hand until the roll lies
between the two roll-off
rollers. If the roll is now
rotated in the roll-off
direction, the roll will automatically
thread itself into the roller device!