KREAFUNK cPURSE Manuel D'utilisation page 8

CHARGING INPUT /
OUTPUT
Charging cPURSE
Use the included - or your own
- charging cable and plug in the
micro USB connector to the micro
USB port in cPURSE (input port).
Then connect the USB connector
to an AC adaptor or USB port on a
computer.
While charging, the blue LED lights
will indicate the charging status
of cPURSE. Each blue LED light
indicates 25% power. cPURSE is
fully charged when all four LED
lights have turned blue.
Charging your smartphone
Use the included charging cable
and plug in the USB connector to
the USB port in cPURSE (output
port). According to your type of
smartphone connect either the
micro USB connector or the iPhone
lightning / USB C adaptor to the
charging port on your smartphone.
8
While charging, the blue LED lights
will indicate the charging status of
your smartphone. Each blue LED
light indicates 25% capacity. Your
phone is fully charged when all four
LED lights have turned blue.
Remark
All LED lights will turn off
automatically after approximately
30 seconds if cPURSE is not
connected to a power source or a
smartphone.
English