Publicité
Les langues disponibles
Les langues disponibles
Lift bucket from frame to
remove for emptying and
cleaning.
Leg Height Adjustment
1. Before use, adjust the height of each
leg to your specific needs, making sure
all legs are at the same height. When
your desired height is reached, lock
legs into place by aligning buttons with
holes until they "snap" into place (see
Figure 1).
2. Make sure legs are locked into place by
pushing down or by pulling up on legs.
CAUTIONS:
1. Toilet seat must be in down position before use. Failure
to do so may result in possible injury or breaking the
commode.
2. Do NOT install commode without first reading and
understanding this assembly and instruction guide.
If you cannot understand these instructions, contact
a healthcare dealer or technician before attempting
assembly. Otherwise, injury or damage may occur.
3. Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE. Contact
Medline at 1-800-MEDLINE.
4. Make certain that the height adjusting buttons snap
into place and fully protrude through the same
respective hole of each leg extension. This will ensure
that the leg extensions are securely locked in position
and an even height is achieved (see Figure 1).
5. Ensure ALL screws, nuts and/or bolts are tightened.
6. Check the tips on the leg extensions for rips, wear or
if they are missing. Immediately replace missing or
damaged tips.
7. All four leg extensions with tips MUST touch the floor
simultaneously at all times.
Figure 1
G1-200X1 (PIC-00244)
REVISED: 03/11/21
Publicité
