Publicité
We greatly appreciate your purchase of this product.
The BU5502 Hard Disc Drive Mounting Kit is designed specifically to
mount the DENON BU5503 Hard Disc to the DN-HS5500 Professional
Media & Controller.
Accessories
Check that the following parts supplied with the product.
q
Owner's Manual ...................................................................... 1
w
Mounting Kit ............................................................................ 1
e
Screws (M3 x 6 mm, Black) .................................................... 2
r
Screws (M3 x 4 mm) ............................................................... 4
t
Hex. Head Screws (M3 x 6 mm) ............................................. 4
y
Hex. wrench ............................................................................ 1
u
Service Station List .................................................................. 1
i
Service Station List (For Japan only) ....................................... 1
Mounting Procedure
1.
Turn the DN-HS5500's power switch off and unplug the power
cord from the power outlet.
2.
Remove the four screws (hexagonal head screws) fastening the
DN-HS5500's front panel, then remove the front panel.
3.
Remove the two screws fastening the plate under where the front
panel was mounted, then remove the plate.
NOTE
Do not put your fingers or other objects into the hole left when the plate
is removed or inside the unit. Doing so could lead to malfunction.
4.
Line up the connector terminal of the hard disc drive (BU5503)
to the connector attached to the mounting kit, then press in the
direction of the arrow on the diagram to attach.
NOTE
Check carefully that the connector is properly lined up before pressing
on the hard disc drive.
5.
Holding the hard disc and mounting kit, turn them over, then fasten
the hard disc drive to the mounting kit using the four included
screws (M3 x 4 mm).
NOTE
The hard disc drive can easily be damaged by shocks. Handle it
carefully so as not to drop it, etc.
Do not touch the circuit boards, connectors or other parts on the
mounting kit.
6.
Holding the mount section of the mounting kit, insert the mounting
kit's metal sheet into the hollow in the rail in the DN-HS5500's
opening and push inside.
7.
Fasten the plate that was removed above to the DN-HS5500
together with the mounting kit using the two included screws (M3
x 6 mm), as shown in the diagram.
8.
Mount the front panel that was removed above to the DN-HS5500
using the four screws (M3 x 6 mm hexagonal head screws)
included with the DN-HS5500.
NOTE
Be sure to format the hard disc drive after mounting it.
For instructions on formatting, see "Initialization" in section A9 , Utility
of the DN-HS5500's owner's manual.
The hard disc drive is now mounted on the DN-HS5500 and will
operate.
Handle the set in which the hard disc drive is installed with sufficient
care.
ENGLISH
Publicité
