Table des Matières
Publicité
Rutland 504 "e-Furl" Windcharger
Further System Requirements
Total = 12v
120Ah
1440Wh
12v
60Ah
12v
60Ah
Batteries in parallel to increase
ampere hours (Fig.13).
Note : Batteries must not be joined
in series as this will increase the
voltage
Cable Specification
Fig 14
Cable
(mm²)
Run (m)
0-20
2.5
21-30
4
31-45
6
46-80
10
Doc. No: SM-151 Issue A 07/01/2011
Batteries
Leisure/Deep Cycle batteries are specifically
designed for good performance in terms of
charge/discharge cycles. Batteries are an
important part of the renewable energy battery
charging system and should be sized according to
the load requirements and provide at least 3 days
reserve capacity. This will reduce cycling,
prolong the life of the battery and ensure system
reliability during periods of low wind.
Permanent connections should always be made
•
to the battery terminals. Never use crocodile clips
or similar devices. Battery terminals should be
well greased with petroleum jelly or similar.
We strongly recommend that one of the charge
•
regulators available from Marlec is fitted to
prevent batteries becoming overcharged in strong
winds and during low energy consumption
periods. A regulator is essential where gel and
sealed batteries are used.
Batteries may be linked as shown in the Fig 13.
•
It is essential to observe polarity as follows:
Red is + Positive
The cable used for connection of the Wind
Cable Size
charger to the batteries should be in accordance
SWG
AWG
with Fig 11. The use of a smaller cable than rec-
ommended will reduce the performance of the
15
13
charging
13
11
11
9
Cable and connectors are available from your
9
7
dealer or the manufacturer.
Black is - Negative
system.
14
Installation and Operation
Marlec Engineering Co
Publicité
Table des Matières
Dépannage
