Montarbo DSI-22 Notice D'emploi page 6

DSI-22
DESCRIPTION
1 2 3
4 5
11
1 INST 1
Press this button if you want to connect an electric instrument (bass, guitar, etc. ..) or
other equipment with high output impedance to channel one 6.35 mm jack input.
10
8
6 7 9
12
2 48V
This button turns 48V phantom power for channels 1 and 2. Make connections before
turning on 48V, and turn off 48V before disconnecting the microphone cable.
3 INST 2
Press this button if you want to connect an electric instrument (bass, guitar, etc. ..) or
other equipment with high output impedance to channel two 6.35 mm jack input.
4 INPUT GAIN CH 1
Adjust channel 1 knob to obtain - as indicated by LEVEL indicators - a level which is ideal
for recording. CLIP leds must flash on musical peaks only.
5 INPUT GAIN CH 2
Adjust channel 2 knob to obtain - as indicated by LEVEL indicators - a level which is ideal
for recording. CLIP leds must flash on musical peaks only.
6 LEVEL
This LEDs indicator shows the signal levels. Adjust the knobs on the sound card and set
the levels correctly from your DAW in a way that CLIP indicators flash on musical peaks
only.
7 MONITOR
10
Use this knob to adjust audio monitors overall output signal level.
8 MIX
This knob adjusts the headphone listening balance between INPUT 1 / INPUT 2 signals
and the one recorded on the PC, called PLAYBACK, thus ensuring zero latency listening.
9 MONO
Press this switch for mono listening.
10 HEADPHONE VOLUME
Use this knob to adjust your headphones listening level. Always start from the minimum
and raise gradually. High-level listening can damage your hearing.
User manual
11