Bahco BCL32RS1 Manuel page 7

5. SPECIFIC SAFETY RULES AND/OR SYMBOLS
Recycle
...................
Do Not Throw in Garbage
..................
a.c.
Alternating Current
...............
W
Watts
....................
mm
Millimeter
..............
kg-cm
Kilograms - Centimeter
.....
/min
Revolutions or Reciprocations per Minute
............
6. FEATURE
1
2
3
7. OPERATING INSTRUCTIONS
Removing or Installing Battery Pack
1. Always switch off the machine before insertion or removal of the
2. To remove the battery pack, push the button on the battery pack and
3. To insert the battery pack, align the tool unit slides with the battery
4. Do not force the battery pack in sliding it into tool unit. If the battery
Charging the Battery Pack
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown
3. Push the battery pack into place and make sure the red light on the
4. A fter finish the charging cycle, the light will turn into green. The
5. Your new battery pack is not charged. You need to charge it before
6. A lways use the specified charger to charge the battery. When the
4 5 6
battery pack.
pull the tool unit from the battery pack in the direction.
pack sliding groove and push the tool unit into place.
The tool unit can be slide into battery pack in two directions.
pack does not slide in easily, it is not being inserted correctly.
on the charger.
charger is "ON". The battery pack is now starting the charging cycle.
battery pack is now ready for use.
use.
battery pack is inserted into the charger correctly, the red light will
come on and charging will begin.
• 7
Class II Tool
...........
V
Volts
..............
Hz
Hertz
..........
kg
Kilograms
...........
d.c.
Direct Current
.......
ft-lb
Foot-Pound
.....
1. Chuck
2. LED
3. Guard
4. Lever For Blade Guard
5. Main Switch
6. Safety Lever
•