Siemens FHA2017-A1 Installation page 3

Align the enclosure by tightening or loosening the
7.
hexagon nuts (6.7) so that the surface of the
operating unit is level with the plaster. This ensures
that the FM blind is level with the wall.
Fix the operating unit (8) to the wall with the two
8.
bottom screws (9).
If available, screw down the operating add-on (5)
9.
using the two top screws (4).
Place the FM blind (3) onto the rear panel so that the
10.
upper angle is placed on the housing (7).
11. Screw down the FM blind with the four fixing screws
(2).
Plug the plastic stoppers (1) into the four fixing
12.
screws (2).
Building Technologies
Fire Safety
Additional documentation
Information about further installation steps can be found
in the document Installation 008851.
3
A6V10331435_a_--_--
11.2011