PNI SafeHome PT330 Mode D'emploi page 5

Android iOS
2. After installation, open the application, create an account and log
in.
3. Enable WiFi (2.4GHz) and GPS Location on your mobile phone.
4. To add the sensor to the application, click on the "+" icon in the
upper right corner.
5. Select from the menu on the left Sensors - Sensor (WiFi)
6. Power on the sensor. The blue LED flashes frequently. If the LED
does not flash frequently, press the Reset key on the sensor for about
5 seconds.
7. Select the WiFi network you want to connect to and add the
network password.
5 - User manual