There is interior moisture build-up (cont.)
Check if ...
The food is not packaged correctly.
The control is not set correctly for the
surrounding conditions.
A self defrost cycle was completed.
The doors will not close completely
Check if ...
Food packages are blocking the door open.
The ice bin is out of position.
The pans, shelves, bins, or baskets are out
of position.
The gaskets are dirty.
The refrigerator is not level.
The doors were removed during product installation
and not properly replaced.
The doors are difficult to open
Check if ...
The gaskets are dirty or sticky.
Then ...
Check that all food is securely wrapped. If necessary,
repackage food according to the guidelines in the "Food
Storage Guide" section. Wipe off damp food containers
before placing in the refrigerator.
Refer to the "Setting the control" section.
It is normal for droplets to form on the back wall after the
refrigerator self-defrosts.
Then ...
Rearrange containers so that they fit more tightly and take up
less space.
Push the ice bin in all the way.
Put all pans, shelves, bins, and baskets back into their
correct position.
Clean gaskets according to the directions in the "Caring for
Your Refrigerator" section.
Level the refrigerator. Refer to the "Leveling" section.
Remove and replace the doors according to the "Reversing
the door swing" section or, contact a qualified person.
Then ...
Clean gaskets according to the directions in the "Caring
for Your Refrigerator" section.
43