Warnings And Error Messages - Nedo PRIMUS 2 H1N+ Long Range Mode D'emploi

EN Operating instructions

10 Warnings and error messages

10.1 Warnings PRIMUS 2 H1N+
Warnings always indicate particular or special operating circumstances. The
red LED of the display panel and the warning symbol
with the display of the warning.
To reset the warning, use the button to switch the laser Off and then back
On again or use the button to switch to MANUAL operating mode.
Display
C00
C01
C02
C03
NOTE
The threshold of the TILT alarm function can be switched between COARSE, FINE and
OFF by NEDO or a service partner. It is therefore possible to deactivate the TILT alarm.
By default, the COARSE threshold is set.
10.2 Error messages PRIMUS 2 H1N+
Display
ERR1 – ERR11
ERR12
Description of the warning
Laser is tilted by more than ±5° and cannot horizontally level itself.
TTILT alarm - The laser was vibrated after 30 seconds expired.
Time exceeded during automatic levelling.
Unallowed change in horizontal position
Description of the error message
Internal unit error Send laser to NEDO's Service department.

If this error occurs more than once,
department.
in the display flash
vertical position.
 
Send laser to NEDO's Service

35