GMV 801 Mode D'emploi page 52

With a 3-4 type tank, proceed as follows:
Take the reinforcement plate, assemble the hand pump and
fasten it with two screws (T.C.E.I. M6 x 55). Take the suction pipe
(copper pipe) and straighten it out. Assemble the pipe on the
hand pump's nipple, put the dust stopping rubber bulb on the
suction pipe. Overlap the reinforcement plate complete with the
hand pump and the suction pipe on the control unit's half lid.
Make sure that the pipe goes through the previously drilled hole.
REINFORCEMENT PLATE
With the m8 x 25 screw, two washers and the Elastic
Stop nut, fasten the group on the half lid using the
second hole and making sure that the group is parallel
to the distributor. Also make sure that the hole for the
ringbolt is centered with respect to the reinforcement plate.
Assemble the hand pump stock and fasten it with the
appropriate clip.Assemble the filter on the suction pipe and
clench with the metal clip.
UNI 5391 T.C.E.I. M6 x 55 SCREWS
PAM 801 HAND PUMP
D9X24
UNI 6593-69 WASHER
DUST STOPPING
RUBBER BULB
SUCTION PIPE
HAND PUMP
STOCK
CLIP
SCREW
M8X25
UNI 5739
ELASTIC
STOP NUT M8
FILTER