Tenergy DQ1007 Mode D'emploi page 6

Setting The Thermostat
1) Turn on the heater, allow it
to warm up the room before
setting the thermostat. Wait
until desired room temperature
is reached.
3) The heater will now
automatically maintain the
set temperature by cycling
the heat on and off.
NOTE: It is recommended to adjust your thermostat with each use. Day
to day changes in room and outdoor temperature will affect the position
at which your thermostat will turn on or off.
Set
2) When desired room
temperature is reached, turn
thermostat knob
counterclockwise toward
slowly until a click sound is heard
and heater stops working.
4) To further adjust the desired
temperature, turn the
thermostat knob towards
to increase the desired
temperature and towards
to lower it.*
*The "click" will only occur when you
turn down the desired temperature
when the heater is on.
Click