Batavia BT-CLB001 Mode D'emploi page 10

English
• Insert the battery (1) into the machine, push the battery
further forward until it clicks into place.
Note: Make sure the battery and machine are lined up correctly.
If the battery does not slide onto the machine easily, don't force
it. Instead, remove the battery; check the top of battery and the
machine slot are clean and undamaged and that the contacts
are not bent.
Charging the Battery
WARNING: Failure to follow the correct procedure when
charging batteries will result in permanent damage.
1. Plug the charger plug into an electrical outlet. The red LED
indicator (5) on the charger (4) will lighten up.
2. Slide a battery (1) onto the battery charger (4).
3. Once charging commences, the red LED (5) will illuminate
and the green LED (6) will flash.
When the battery is fully charged, the green LED (6) will
4.
illuminate.
Note: Make sure the battery and battery charger are lined up
correctly. If the Battery does not slide onto the battery charger
easily, don't force it. Instead, remove the battery; check the top
of battery and the battery charger slot are clean and undamaged
and that the contacts are not bent.
Battery Charge Level
The battery has a built-in charge indicator. Pressing on the
button (3) to the right will indicate the charge level. The right LED
indicates a high charge level and the left a low charge level that
will mean the battery pack will require charging soon.
IMPORTANT: When a low charge level is indicated be aware
the tool may stop operating while using the tool. In some
instances this may be dangerous. It is recommended to always
ensure the battery pack has a good charge level.
10