Gazelle G9706 Guide De Démarrage Rapide page 4

Component
Trigger
Autofocus
Cable Interface
3. Charge Device
After the device starts up, the OSD (on-screen display) shows the battery status. When the battery is low, charge
the device and ensure it works properly.
For the first charge, charge the device for 10 hours when the device is turned on.
Note：

The built-in cell battery that powers the real time clock (RTC) of the device may drain during longtime
transportation or storage. It is recommended to recharge the RTC battery for the wellfunctioning of the
device clock.

To fully charge the RTC battery, the following requirements should be met:
a) The rechargeable lithium batteries should be installed on the device.
b) The device should keep working for more than 10 hours before shutting down.
3.1 Charge Device via Cable Interface
Steps
1. Lift the cover of interface.
2. Plug in the cable, and charge the device.
3.2 Charge Device via Charging Base
Steps:
1. Hold the device, and press both battery lock catches of the device.
2. Hold the lock catches, and draw the battery base to take out the battery.
3. Insert the battery into the charging base. You can see the charging status via the pilot lamp on the
charging base.
4. When the battery is fully charged, draw the battery from the charging base.
5. Insert battery into the device.
Note: Please charge the device with the cable and power adapter supplied by the manufacturer (or according to
the input voltage from the specifications).
Pull the trigger to capture or scan the QR code.
Hold the trigger to record videos.
Pull the trigger to turn on/ off autofocus function.
Charge the device or export files with supplied cable.
Function
2