Power Fist 3400217 Manuel page 3

V 1.40
SPECIFICATIONS
Avg. air consumption 3.0 CFM @ 90 PSI
Cont. air consumption 12 CFM @ 90 PSI
No load speed 21,000 RPM
Collet 1/4 in.
Air inlet 1/4 in. NPT
IMPORTANT SAFETY PRECAUTIONS
WARNING! Read and understand all instructions before using this tool. Failure to follow all instructions may
result in electric shock, fire and/or personal injury. Keep this manual for the safety warnings and precautions,
operating, inspection and maintenance instructions. When using this tool, basic precautions should always
be followed to reduce the risk of personal injury and/or damage to the equipment. Note that when this manual
refers to a part number, it refers to the parts list included.
WORK AREA
1. Keep your work area clean and well lit. Cluttered and dark areas invite accidents.
2. Operate in a safe work environment. Do not use in damp or wet locations. Do not expose to rain. Do not use
in the presence of flammable gases or liquids.
3. Keep children, bystanders and visitors away from the work area. Distraction can cause you to lose control.
Do not let them handle tools, hoses or extension cords. No one should be in the work area if they are not
wearing suitable protective equipment.
4. Store unused equipment. When not in use, tools must be stored in a dry location to prevent rust. Always
lock up tools and keep them out of reach of children.
PERSONAL SAFETY
1. Use eye, face, head, breathing and ear protection. Always wear ANSI approved impact safety goggles, which
must provide both frontal and side protection. Protect your hands with suitable gloves. Wear a full face
shield if your work creates metal filings or wood chips. Wear an ANSI approved dust mask or respirator
when working around metal, wood and chemical dusts and mists. Wear ANSI approved earplugs.
2. Do not over reach; keep proper footing and balance at all times. Proper footing and balance enables better
control of the tool in unexpected situations.
3. Dress properly, wear protective equipment. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Tie back long hair. Protective, electrically non-conductive clothes and non-skid footwear are
recommended when working.
4. Stay alert, watch what you are doing and use your common sense. Do not operate any machine or tool when
you are tired, under the influence of drugs, alcohol or medications.
5. Use clamps or other practical ways to secure and support the work piece to a stable platform. Holding the
work piece by hand or against your body is unstable and may lead to loss of control.
For technical questions call: 1-800-665-8685
1/4 in. Variable
Speed Professional
Die Grinder
3400217
3