Conceptronic CMED3PLAY Guide D'installation Rapide page 25

ENGLISH
6. HOW TO CONNECT THE GRAB 'N' GO MEDIA PLAYER
6.1 Connection to your Television
Connecting the device with a TV (illustrated as follows)
The three RCA connectors (yellow, red, white color) of the AV cable should match with the
corresponding input jacks on your TV. (dit ervoor in de plaats) If your TV has no Composite
input available, use the included SCART to Composite/Audio cable.
NOTE:
The Conceptronic CMED3PLAY can be used with a television or with a monitor
When using a TV you have to use the S-Video, Composite or Composite to SCART cable.
Please check the manual of your TV to select to correct input channel to display the video
output of the CMED3PLAY. If you have used the CMED3PLAY in VGA mode, please press the
VGA button on your remote control to change the VIDEO output again to your TV.
When using a monitor you have to use a monitor VGA cable and connect it to the VGA OUT (6)
connector. Press the VGA button on the remote control (a number of times) until the monitor is
switched on automatically (out of Stand-By mode).
To switch between the various modes available (VGA, TV, S-VIDEO) you need to press the
VGA button on the remote control.
25