Sony FW-100BZ40J Manuel D'installation page 11

Note
• Be sure to fasten the Wall-Mount Attachment when
attaching them to the LCD Monitor. Use only a flat
head screwdriver to install the Wall-Mount
Attachment. Use of another tool might result in
over torqueing the Wall-Mount Attachment and
damaging the LCD Monitor.
3
Attach the Wall-Mount Bracket
(not supplied) using the screws
(not supplied).
Note
• If using an electric screwdriver, set the torque at
approximately 1.5 N·m {15 kgf·cm}.
Wall-Mount Bracket
(not supplied)
Screw (not supplied)
4
Detaching the Table-Top Stand
from the LCD Monitor.
 Remove one side of the Table-Top Stand at a
time. Firmly hold the Table-Top Stand
securely with both hands while the other
people lift up the LCD Monitor.
 Repeat the previous step and remove the
other side of the Table-Top Stand.
Note
• Three or more people are required to detach the
Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the LCD
Monitor as it may cause the LCD Monitor set to fall
resulting in personal injury or physical damage to
the LCD Monitor.
• Take care when handling the Table-Top Stand to
prevent damage to the LCD Monitor.
• Be careful when lifting the LCD Monitor as the
Table-Top Stand is detached, the Table-Top Stand
may topple over and cause personal injury.
• Take care when removing the Table-Top Stand from
the LCD Monitor to prevent it from falling over and
damaging the surface that the LCD Monitor is
sitting on.
• Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on
the LCD Monitor.
• Be sure the LCD Monitor is vertical before turning
on. To avoid uneven picture uniformity do not
power on the LCD Monitor with the LCD panel
facing down.
11
(GB)