Mopar 82207853AB Mode D'emploi page 2

GB
■ Disconnect and isolate negative battery cable.
■ Disconnect and remove overhead console or dome lamp, if equipped.
■ Remove left (driver's side) A-pillar trim panel and left I\P access panel.
■ Remove I/P center cluster bezel. Disconnect and remove radio.
■ Remove knee blocker panel(s).
■ Install kit components as described in notes and as shown in illustrations. Ensure that all vehicle mounting
surfaces are clean.
■ Route Item F 22-way connectors and Item E cable connector up into the I/P at the knee blocker opening,
and out of the radio opening. Keep away from sharp edges, heat sources, or moving parts.
■ 2002-2005 Vehicles: Plug Item F 22-way connectors into radio and radio connector.
1990-2001 Vehicles: Follow procedure shown on page 5. Securely crimp a ground eyelet or a blade
terminal to the black wire.
■ Make electrical connections to items A, C, D, and E. When connecting to module (Item A) make sure
connector lever is engaged in the locked position.
■ Loop-up slack in harness and cables. Apply tie straps and stow away neatly. Do not kink or tightly coil the
cables.
■ Re-install vehicle components and trim panels, ensuring that cables are not pinched under them.
■ Perform a functional check of the system by following the steps shown on page 24 of this document.
ITEM A:
Place supplied 2-way tape to underside of module. Ensure tape contacts to vehicle mounting surfaces. Install
tie straps and mounting screws if needed.
ITEM B:
Measure for bracket mounting holes as shown in illustrations. Using the bracket as a template, drill two 1/8"
holes. Install bracket with supplied screws.
ITEM C:
Install speaker to mounting bracket. Position speaker as shown in illustrations. Tighten thumb screw with flat
blade screwdriver (do not overtighten).
ITEM D:
Remove backing from 2-way tape at underside of microphone. Install mic to overhead console or dome lamp if
equipped. Using a small circular file, make a notch in the console/dome lamp bezel edge closest to the mic.
Route mic cable under headliner towards left A-pillar.
ITEM E:
Secure control pad cable inside trough at the back of the unit. Remove backing from 2-way tape at underside of
control pad. Install control pad to I/P center console bezel using a small circular file, make a notch in the inner
edge of the radio or HVAC opening closest to the control pad.
01-25-2005
IMPORTANT NOTES
2 of 24 K6858681