BOMANN SMS 6055 CB Mode D'emploi page 39

NOTE:
Of course, you can chop also other foods that are not
specified herein. In order to determine the maximum time
for a type of food that is not specified herein, compare it
with the hardness of another type of food provided in the
table, i. e. an Apple has the same insistence of onion.
5. Seal the bowl again with the lid; the recesses on the
lower edge of the lid and on the upper edge of the bowl
must interlock.
6. Place the motor casing on the upper opening of the lid
and fasten the multi-dicer by turning it to the right.
7. Only connect the appliance to a properly installed safety
socket. Allow the multi-dicer to stand on the surface dur-
WARNING:
• Always pull the plug out of the socket before cleaning!
• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an
electric shock or fire.
• The multi-purpose knife and the knife on the stick blender are
very sharp. Handle these parts with care! There is a risk of
injury!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Do not immerse the gear unit for the egg whisk (4) in
water! Wipe it using only a damp cloth.
• Do not fill the bowl with boiling water.
NOTE:
• To pre-clean the accessories, fill a container with hot
water and operate the whisk and / or the mixing rod in
it as described under "Operation".
• Some foods such as carrots or eggs can discolour
the plastic. Remove such discolouration with a cloth
moistened with vegetable oil.
• To clean thoroughly, detach the stick blender or egg
whisk from the motor housing.
• Removable parts which have come into contact with food
(tool and container) can be cleaned in soapy water. You
can add a commercially available washing-up liquid.
SMS6055CB_IM
ing operation until you remove the multi-blade (7). Hold
the multi-dicer firmly with a hand.
8. Press one of the buttons on the two-level control switch.
After Use:
1. Release the motor housing from the multi-dicer by turn-
ing it and then remove it from the lid.
2. Remove the lid and pull the multi-blade out carefully. .
WARNING:
The multi-blade is very sharp! Danger of injury!
3. Pour the contents of the container into a container or
plate.
Cleaning
• Rub the outside of the motor casing with a moist towel to
clean it when necessary and then wipe it with a dry cloth.
• Clean the appliance as described and allow it to dry.
• After cleaning, store the mixing rod in the accessory
holder supplied (see illustration D). Tighten the attach-
ments and the mixing rod with one clockwise turn to
prevent the attachments from falling down.
• We recommend that you keep the appliance in the origi-
nal packaging if it will not be used for long periods.
• Always store the appliance out of the reach of children in
a dry, well ventilated place.
Storage
12.10.21
39