Channel Delay - Coby DVD938 Manuel D'instruction

System Setup
R-MONO: The player outputs the right-channel audio only via both

the FL and FR speaker.
MIX-MONO: The player outputs the average signal of the left-chan-

nel and right channel audio via the FL speaker and the FR speaker.
This function only applies to Dolby AC -3 and 2-channel en-
coded discs.
Dynamic
When you watch films with large dynamic audio range at low volume
(at night, for example) you can increase the dynamic value to avoid
losing sonic detail resulting from the low volume.

Channel Delay

Set the delay time for the center, rear speakers and the subwoofer.
You may need to set a delay to compensate for the difference in audio
propagation times caused by the distance of the speakers to the
listener.
Use the navigation keys <UP> or <DOWN> to select a speaker, then use
the navigation keys <LEFT> or <RIGHT> to adjust the distance differen-
tial.
This unit does not support delays for when the distance be-
tween the center or surround speakers and the listener are
greater than that between the front speakers and the listener.
In case the channel delay settings cannot match your speaker
configuration, please set all distances to 0cm. If possible, use
your receiver/amplifier to set the channel delay.
Page 40 Coby Electronics Corporation