Eton BLACKOUT BUDDY Manuel De L'utilisateur page 5

AUDIBLE & VISUAL SIGNALS
POWER
HORN GREEN LED
Previous * See below
CO alarm or
Previous
Gas alarm
or both
1 chirp * See below
approx every
40 seconds
3 chirps * See below
approx every
40 seconds
2 chirps * See below
approx
every 20
seconds
* During 120 Volt Operation: On and Blinks Off approx every 20 seconds.
During 9 Volt (DC Backup) operation: Blinks On approx every 40 seconds
RECOMMENDED PLACEMENT:
NOTE: For any location, make sure no door or other obstruction could prevent the carbon
monoxide or gas from reaching the alarm.
OPERATIONAL SUMMARY
GAS CO
BLUE LED RED LED
_ _
Off Off
Off Off
Off Off
CONDITION / RECOMMENDATION
Condition: Alarm needs to be reset due to abnormal
operation/previous alarms.
Recommendation: Press the TEST/SILENCE or
PEAK/RESET button for approx. 10 seconds. The alarm
will chirp once to indicate the reset is now complete.
Release button. This will clear the alarm LED's and clear
the Silence mode.
MCND401 and MCND601 Series only: To reset the peak
CO memory, press and hold the PEAK/RESET button for
approx. 10 seconds until the peak level is cleared. The
alarm will chirp once to indicate the reset is now
complete. The display screen will display "000" when the
peak CO level is reset and then return to "- - -."
Condition: Low Battery
Recommendation: Check to make sure the battery
activation pull tab has been completely removed, battery
polarity is correct and the battery terminals are making
contact with the alarm contacts in the battery compartment.
If chirp continues, replace the 9V battery (see User's
Manual for recommended battery types).
Condition: Sensor Trouble/End-of-Life/Service Alarm.
Recommendation: Reset the alarm. If this does not clear
the problem, replace the alarm.
Condition: End-of-Service Life Alarm.
Recommendation: Replace the alarm.