Eton BLACKOUT BUDDY Manuel De L'utilisateur page 4

WIFI CONNECTIVITY VIA THE ETON SMART APPLICATION FOR IOS OR ANDROID
Blackout Buddy Connect Combo
https://vimeo.com/etoncorp
For support or questions please contact: customer_support@etoncorp.com
Note: The Blackout Buddy Connect Combo only supports 2.4GHz WiFi networks, if you have
a dual-mode (2.4GHz & 5GHz) combination router please ensure that the 2.4GHz radio is
turned on and broadcasting. Consult your router's user manual for more information.
AUDIBLE & VISUAL SIGNALS
POWER
HORN GREEN LED
Silent On and Blinks
Off approx every
20 seconds
Silent Off and Blinks
On approx every
40 seconds
1 beep, Turns Off in
1 second sync with
pause, cycle of the
4 beeps first beep
4 beeps, Blinks Off when
5 second the Red LED
pause, blinks On
repeat
* S e e
1 beep,
1 second
pause,
repeat
Horn sounds On and blinks
when no Off approx
hazard is every 20
present seconds
* See below
4 beeps,
5 second
pause,
repeat
i S e l t n
* See below
* See below
Silent
OPERATIONAL SUMMARY
GAS
BLUE LED
Off
Off
Blinks in
sync with
cycle of the
first beep
Off
b e o l w Blinks in
sync with
cycle of the
first beep
Blinks when
no hazard is
present
Off
O f f
Off and
blinks On
approx every
5 seconds
until reset
CONDITION / RECOMMENDATION
CO
RED LED
Off Condition: AC Power is present. DC power is present.
Recommendation: None, alarm is operating properly.
Off Condition: Alarm is powered by battery backup. AC Power
is not present.
Recommendation: Check the breaker or fuse box for power.
If the breaker or fuse box looks normal, call a licensed
electrician for assistance.
Blinks in Condition: The TEST/CO SILENCE button has been
sync with pressed and released. The test sequence lasts for
cycle of approximately 3 seconds after the button is released.
4 beeps Recommendation: None.
Blinks in Condition: CO alarm
sync with Recommendation: If a hazard is identified, please take
cycle of all precautions when an alarm sounds by calling an
4 beeps Emergency Service and getting out of the home.
O f f Condition: Gas alarm.
Recommendation: If a hazard is identified, please take
all precautions when an alarm sounds by calling an
Emergency Service and getting out of the home.
Blinks when Condition: Nuisance Alarm.
no hazard Recommendation: If there is no hazard present, verify the
is present alarm is mounted in the correct location (see User's
Manual, "AVOID THESE LOCATIONS" section). Reset
alarm as instructed below.
Blinks in Condition: CO alarm when cause of alarm is known and
sync with poses no threat.
cycle of Recommendation:
4 beeps activated by pressing and releasing the TEST/CO
SILENCE button on the initiating alarm while in alarm
condition. The alarm will remain silent for approx 5
minutes, depending on the level of CO detected. If CO
levels drop below alarm levels, the alarm will remain silent
and return to normal operation. If CO levels remain
constant or increase, this indicates potentially dangerous
situation and the horn will sound again. Ventilate area.
Off and Condition: Latching CO LED Indicator. The alarm has
blinks On previously detected CO and had alarmed.
approx every Recommendation: Follow the reset instructions to remove
5 seconds the latching LED.
until reset
Off Condition: Latching Gas LED Indicator. The alarm has
previously detected Gas and alarmed.
Recommendation: Follow the reset instructions to remove
the latching LED.
The CO Alarm Silence Feature is