pack but may be easily knocked over.
SYMBOLS
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ......alternating current
or DC ...direct current
n o ................no load speed
................Class I Construction
(grounded)
FUNCTIONAL DESCRIPTION
1. On/Off button
2. Pivoting 12 LED light housing
These products use the batteries and chargers listed in the chart below.
Description
20v Max** Lithium-Ion Battery:
20v Max** Lithium-Ion Battery:
20v Max** Type 1 22wh Lithium-Ion Battery:
Lithium 2 Amp Fast Charger:
Lithium 2 Amp Fast Charger:
20v Max** Lithium-Ion Battery Charger:
20v Max** Lithium-Ion Battery Charger:
20v Max** Lithium-Ion Battery Charger:
20v Max** Lithium-Ion Battery Charger:
IMPORTANT SAFETY
INSTRUCTIONS FOR
BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This
manual contains important safety
instructions for battery chargers.
• Before using charger, read all instructions
and cautionary markings on charger, battery
pack, and product using battery pack.
WARNING:
allow any liquid to get inside charger.
CAUTION:
Burn hazard. To reduce the
risk of injury, charge only designated
BLACK+DECKER batteries. Other types of
batteries may burst causing personal injury
and damage.
CAUTION:
with the charger plugged in to the power
supply, the charger can be shorted by
foreign material. Foreign materials of a
conductive nature such as, but not limited
to, steel wool, aluminum foil, or any buildup
of metallic particles should be kept away
from charger cavities. Always unplug the
charger from the power supply when there
is no battery pack in the cavity. Unplug
charger before attempting to clean.
• DO NOT attempt to charge the battery
Shock hazard. Do not
Under certain conditions,
................earthing terminal
................safety alert symbol
................Class II Construction
.../min or rpm...revolutions or
............Read instruction manual
................Use proper respiratory
................ Use proper eye protection
................Use proper hearing
2
pack with any chargers other than the
Catalog #
ones in this manual. The charger and
LBXR20
battery pack are specifically designed
LBXR20BT
LB20
to work together.
L2AFC
• These chargers are not intended for any
L2AFCBST
LCS20
uses other than charging designated
LCS201
BLACK+DECKER rechargeable batteries.
LCS1620
LCS200
Any other uses may result in risk of fire,
electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when
disconnecting charger. This will reduce
risk of damage to electric plug and cord.
• Make sure that cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• Do not use an extension cord unless it is
absolutely necessary. Use of improper
extension cord could result in risk of fire,
electric shock, or electrocution.
• An extension cord must have adequate wire
size (AWG or American Wire Gauge) for
safety. The smaller the gauge number of the
wire, the greater the capacity of the cable,
that is 16 gauge has more capacity than 18
gauge. When using more than one extension
to make up the total length, be sure each
individual extension contains at least the
minimum wire size.
Volts
120V
More Not more
Than Than
6 -
10
• Do not place any object on top of
charger or place the charger on a soft
surface that might block the ventilation
slots and result in excessive internal
4
(double insulated)
reciprocation per minute
before use
protection
protection
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0-25
26-50
51-100
(0-7,6m)
(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Ampere Rating
American Wire Gauge
18
16
14
1
101-150
12