ASROCK G31M-VS2 Mode D'emploi page 15

2.6 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

Primary IDE connector (Blue)

(39-pin IDE1, see p.2 No. 8)

connect the blue end

to the motherboard

80-conductor ATA 66/100 cable

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

(SATAII_1:

see p.2, No. 10)

(SATAII_2:

SATAII_4 SATAII_3 SATAII_2 SATAII_1

see p.2, No. 11)

(SATAII_3:

see p.2, No. 12)

(SATAII_4:

see p.2, No. 13)

Serial ATA (SATA)

Data Cable

(Optional)

ASRock G31M-VS2 Motherboard

connect the black end

to the IDE devices

These four Serial ATAII (SATAII)

connectors support SATAII

or SATA hard disk for internal

storage devices. The current

SATAII interface allows up to

3.0 Gb/s data transfer rate.

Either end of the SATA data cable

can be connected to the SATA /

SATAII hard disk or the SATAII

connector on the motherboard.

1 5