Rating Plate; Operation And Handing; Switch-On - Ellrona 61492 Mode D'emploi

• Only use the automatic temperature controller which has been supplied with the
device. Never use a different controller.
• When connecting the automatic temperature controller make sure that it has been
plugged in correctly. Do not pull the cable but the plug of the temperature controller.
Do not handle with exaggerated force or bend.
• Always keep the temperature controller and the pin of the holder clean.
• Turn off and immediately stop using the automatic temperature controller in case it
is damaged or overheated. Do not check yourself. Take the device to the next
authorized dealer and have it repaired
• Before using or removing the automatic temperature controller make sure that the
scale is turned off as it may otherwise lead to overheating or failure.
•
The temperature regulator must not come into contact with the device! Always pull
out the plug before removing the temperature regulator!

13.3.1 Rating plate

The rating plate with the connection and performance data can be founded on
the back of the device.
14

Operation and Handing

This chapter provides you with important notices with regard to operating the
device. Observe the following notices to avoid dangers and damages:
►
Do not leave the device unsupervised when it is in operation, so that you can
intervene quickly in the event of dangers.

14.1 Switch-On

Then put the plug in a 230 volt safety-contact power
outlet.
Please use the temperature adjust scale different concerning the meal you are preparing.
The temperature sensor is designed to maintain the temperature.
ellrona Partypfanne
Warning
First of all put the temperature adjust scale to the
position „OFF" and then assert the automatic
temperature controller in the holder "A"
If the temperature controller isn't fixed properly, a very
high temperature can arise which can cause injuries or
damages to the
appliance. Please
ensure that the
temperature controller is
plugged in correctly.
31