Publicité
Les langues disponibles
Les langues disponibles
is about 1,5 cm below the upper edge of the device (fig. 5).
3.
Select heating in the display (fig. 6). Wait for the status LED to glow.
4.
Heating time may vary, depending on the amount of milk or water and initial
temperature.
NOTE
It is advisable to serve milk to the child shortly after heating. Avoid milk reheating.
Always check milk temperature before you serve it to the child (fig .7).
Food heating
1.
Place a container with food in the warmer (fig. 8).
2.
Pour water into the warmer until you reach food level in the container. In case of
a large amount of milk or water, the maximum amount of water in the warmer is
about 1,5 cm below the upper edge of the device (fig. 9).
3.
Select food heating in the display (fig. 10). Wait for the status LED to glow.
4.
It is advisable to stir food while heating (fig. 11).
5.
Before serving, always check food temperature (fig. 12).
NOTE
Due to high diversity of baby food consistency, it is advisable to frequently stir it and
inspect the temperature. It is not possible to precisely specify food heating time.
Disinfecting
1.
Before you start disinfecting, wash and carefully rinse the bottle and accessories.
2.
Place accessories and a bottle upside down in the warmer (fig. 13).
3.
Pour about 50-100 ml of water into the warmer (fig. 14).
4.
Select disinfection in the display (fig. 15). Wait for the status LED to glow.
5.
When water evaporates, the device shuts down automatically.
Cleaning
1.
After every use and before cleaning, unplug the device. Wait so that the device
can cool down before you start cleaning.
2.
Remove water from the device (fig. 16).
3.
If you have heated food in the device, make sure there are no remains at the bottom.
4.
Wipe the housing and interior of the warmer with a soft wet cloth, and then wipe
it dry with a clean cloth or paper towel (fig. 17).
5.
For cleaning, do not use scrub sponges, scrub agents or any other caustic substances
or chemicals.
Descaling
1.
It is advisable to perform descaling on a regular basis, that is every four weeks, to
assure correct operation of the device.
2.
Pour 50 ml of white vinegar and 100 ml of cold water into the device.
3.
Turn the device on and then select milk heating. Let the device work for 10 minutes.
4.
Leave the solution in the device until descaling is successful.
EN
‑ 8 ‑
Publicité
