TaoTronics TT-AP001 Mode D'emploi page 8

Installing and Removing the Filter
Filter Reset Indicator
The flickering FILTER RESET LED indicates that it is time to replace the f ilter. Replace
the filter according to the directions below, then press and hold the POWER /
FILTER RESET button for 5 seconds to reset the light, and it will stop flickering.
* Replace the filter every 3 to 6 months depending on the usage.
EN I II III SLEEP I TURBO II III
ON/OFF RESET
1. Lift the unit upside down.
2. Remove the base by unscrewing the screw cap.
09
3. Take out the dirty f ilter and
replace with a new one.
4. Reattach the base to the unit and
fasten it with the screw cap.
I II III SLEEP I TURBO II III
ON/OFF RESET
10
EN