Vetus ELPS Manuel D'utilisation page 7

3 Operation
3 .1 The motor control panel
START/STOP control button
With this button the system can be switched
on and off. In addition, this button can be
used to take over the command if multiple
steering positions are used.
PWR - Power mode
Pressing the POWER modus button unleashes
the electric peak power of the E-drive motor.
Press the button again to return to the NOR-
MAL mode.
The POWER mode will automatically switch
off after a few minutes, after which the mode
will be temporarily unavailable.
ECO - Eco mode
By pressing the ECO modus button the maxi-
mum output power of the E-drive motor is
limited. Press the button again to return to the
NORMAL mode.
3 .4 Meaning LED indicator lights
START/STOP button
BLUE LED RED LED
Blinks (for 6s)
ON
Blinks double
Blinks fast
OFF
Blinks
OFF
Blinks double
OFF
Blinks fast Blinks
Blinks fast Blinks fast
ON
ON (for 5 sec)
vetus® User manual E-Drive motor control lever ELPS - ELPSR
3 .2
• Turn on the key switch.
ELPS
• Move the lever to the neural position. Gently press the 'START/
After the switch is pressed once the LED will flash green and the
buzzer will sound continuously didididididi..... (. . . . . . .) The 'START/
STOP' button must be pressed a second time within 6 seconds. The
LED (blue) will remain on and the buzzer will confirm that the panel
is ready for use by giving the signal dahdidah (- . -).
If a second panel is connected the LED on the panel 'which has not
been switched ON' will flash (every second two short blue flashes,
heartbeat).
ELPSR
3 .3
Press once the 'START/STOP' button, the buzzer will reply with the
signal didididahdidah ( . . . - . - ).
• Turn off the key switch.
• Turn off the battery main switch when leaving the boat.
PWR button
BUZZER
BLUE LED
(.) (for 6s)
1x (-.-)
ON
1x (.-.)
1x (.)
1x (.-..-)
1x (..)
1x (.-..-)
1x (..)
1x (.-..-)
1x (..)
1x (.-..-)
1x (..--..) , ∞ (.)
1x (.-..-)
Switching on a panel
STOP' button twice in succession.
Switch off a panel
ECO button
GREEN LED
Childlock after the first push
System enabled after second push
Control panel is inactive, motor is active
ON ECO mode is active
POWER mode is active
POWER mode about to become inactive
After POWER button is pushed POWER mode
not available
After lever is moved (neutral to left/right)Motor
is propelling
Motor is overheated
Motor was overheated
Motor is overloaded
Motor was overloaded
Motor output power is limiting
Motor output power no longer limited
Motor voltage supply is low
Panel V-CAN voltage supply is low
Disconnected from V-CAN network
Lever is broken
ENGLISH
7
0370401.02