Plug IN
Make sure the control knobs are in the off position.The Griddle must be connected using the
connection under (3/8 flare)
The hose length must be suitable for your use and visible along its entire length, without
exceeding 1.5m.
Check that the flexible hose is in good condition and do not hesitate to change it if it looks
cracked or damaged. The flexible hose must not be twisted or pulled and must not come into
contact with hot parts of the appliance. After connecting the hose to the appliance, connect
the pressure regulator to the hose and the gas cylinder, following the instructions supplied
with the pressure regulator and the hose. Then check for gas leaks as follows:
Check for leaks using soapy water, away from any heat sources (cigarette, electrical appliance,
etc.).
Never test for leaks using a flame.
• Put soapy water on all the connections, turn on the gas inlet and check whether any bubbles
form.
• The presence of a bubble = gas leak; shut the gas cylinder and tighten the connections again.
Repeat the test for leaks.
• If the leak persists or comes from another part, do not use your Griddle and contact the
manufacturer.
DANGER:
NEVER USE AN APPLIANCE THAT LEAKS.
Société SISTERIA 449 Avenue du Danemark 82000 Montauban FRANCE
Page 16