INTERTECHNO CMR-2000 Mode D'emploi page 21

GB
2000
g If no signal is transmitted within 12 seconds, the learning process is
automatically aborted.
16 different codes or transmitters can be taught in per channel.
The encoding remains saved even after a power cut.
g in a Erasing individual codes:
Proceed as described in points 4.) and 5.), however, press the OFF but-
ton instead of the ON button.
u-
Erasing all codes:
Hold down the learn button (L) for approx. 6 seconds until the LED
flashes quickly.
Briefly release the button and then press the learn button (L) again.
The delete process is confirmed by switching twice.
To view the declaration of conformity, please visit
www.intertechno.at/CE
o
i-
t
LED
smi-
ode
›
Operating instructions
CMR-2000