Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
Base is unstable.
Noise from moving parts.
Running
belt
is
centered.
The
computer
screen
does not display clearly.
The computer does not
work at all.
TROUBLESHOOTING
POSSIBLE CAUSE
There is an object under the main frame
of the treadmill, or the ground isn't level.
The lock knob is loose.
Hardware: nuts, bolts, or screws are
loose.
Running belt and running board are not
lubricated.
Running belt tension is not accurate on
not
the left or right sides of the running
board.
The batteries are low.
One of the following sensor wires is not
connected correctly: the Sensor Wire
(No. 46), Lower Sensor Wire (No. 22A),
or Upper Sensor Wire (No. 22B).
The batteries are unresponsive.
Remove the object.
Move the treadmill to level ground.
Tighten the lock knob.
Inspect hardware and tighten.
Lubricate running belt and running board
(see Pg. 9).
Adjust the adjustable bolts, refer to
Maintenance Instructions (see Pg. 9).
Replace with new batteries.
Check the connections of the sensor
wires, make sure they are attached
correctly.
Replace with new batteries.
12
SUGGESTED ACTION
Version 2.7
Publicité
