Playing a record
Before playing a record
1. Return the cartridge's protector to its original up position.
• If the tonearm is fixed to the tonearm rest, remove the clamp.
Protector
2. Place the record on the platter so that the center hole aligns with
the spindle.
• If playing a 45 RPM record, attach the 45 RPM adapter (see the diagram to
the right below).
At 33-1/3 RPM
Record
Platter
Playing a record
Lower the volume of the amplifier, speakers, etc., sufficiently.
1. Use the control knob to select the speed.
• Select "33" for a 33-1/3 RPM record, or "45" for a 45 RPM record.
• The platter begins spinning.
2. Raise the tonearm by lifting the tonearm lift control lever to the
UP position.
3. Position the tonearm over the desired location (groove) on the
record.
4. Lower the tonearm by moving the tonearm lift control lever to the
DOWN position. The tonearm descends slowly onto the record
and play begins.
At 45 RPM
45-RPM
adapter
Tonearm lift
control lever
• Alternatively, you can skip steps 2 to 4, and use your fingers to lift the
headshell, move the tonearm over the desired location on the record, and
then place the headshell down to begin playing the record.
• Do not subject the product to strong impact during playback.
Pausing the record
1. After lowering the volume of the amplifier, speakers, etc.,
sufficiently, lift the tonearm with the tonearm lift control lever.
Stopping the record
1. Lower the volume of the amplifier, speakers, etc., sufficiently.
2. Lift the tonearm lift control lever, return the tonearm to the
tonearm rest, and fix it with the clamp.
3. Turn the control knob to the "STOP" position.
• The platter slows down and rotation stops.
4. Remove the record after the platter has come to a complete stop.
• To prevent the record from becoming scratched or warped, remove it
after use.
• Do not use a platter other than the one provided.
• This product is not intended for DJs. Do not touch the record or the
platter while the record is playing.
Care
Turntable body
• When the turntable body is dirty or dusty, first disconnect the power
cable plug, and then wipe off the dirt and dust with a soft, dry cloth.
• Do not use benzenes, thinners, etc.
• When storing the product for a long time, disconnect the power
cable plug from the outlet and wrap the equipment in plastic; do not
allow it to become damp.
Stylus tip
• If dirt and grime are stuck to the stylus tip, clean it with a
commercially sold brush.
• We recommend using a stylus cleaner (sold separately) if the stylus
tip is considerably dirty. Clean the stylus tip by moving the brush
from the rear to the front of the stylus tip.
33
STOP
45
E
N
8