PRONIVO SmartTRAK ST101 Mode D'emploi page 21

For example, pressing the
once will raise the volume to the next
highest level. The bar graph below shows
lowest and highest volume level (no wave
bar is level 1; four wave bars is level 5).
VOL
VOL
Level 1 = lowest volume level
VOL
Level 5 = highest volume level
Audio Indication
MODE
The audio output when no ferrous metal
STANDARD
objects are detected is a low frequency
ERASE
SMART
10Hz tone. When a ferrous metal object
is detected, the magnetic eld strength
is indicated by the frequency of the audio
tone. The higher the frequency of the
audio tone, the greater the magnetic eld
strength of the object being detected.
Numeric Signal Indication
A two-digit numeric display 2h shows the
magnetic eld strength that is related to
the audio output, where
is equivalent to an audio frequency of
10Hz. The greater the numeric display
indication 2h the greater the magnetic eld
strength of the object being detected. A
numeric indication of
Decreasing the sensitivity
numeric indication is peaked at
aid in pinpointing an object of interest.
VOL SENS VOL
Analog Bar-Graph Signal Indication
SENS VOL
The bar graph display 2c expands from left
to right on the LCD in relation to the audio
signal output from the speaker and the
numeric indication on the LCD.
7 button
erase
MODE
SENS VOL
SENS VOL
VOL SENS VOL
SENS VOL
MODE
STANDARD
ERASE
SMART
on the display
VOL SENS VOL
SENS VOL
is the maximum.
MODE
STANDARD
VOL ERASE SENS
SMART
6 when the
SENS
erase
MODE
MODE
STANDARD
ERASE
SMART
Polarity Indication (ST102 Model Only)
VOL
The polarity indicator 2b shows the polarity
VOL
of the signal being detected.
The polarity indication is useful when
looking for stakes or pins. In the Northern
Hemisphere, the polarity indication at the
top of the stake or pin will be
polarity. In the Southern Hemisphere, the
MODE
polarity indication at the top of the stake or
STANDARD
ERASE
pin will be
SMART
Power Line Indication Feature
The Power Line Indication Feature
activated every time the locator is turned
on and cannot be disabled
The electromagnetic elds caused by AC
current owing through overhead or buried
power lines are detected by the uxgate
sensors. When these AC currents are
VOL SENS
detected, the AC Power Line Indication
SENS
2a will ash. This feature will only
indicate 50Hz and 60Hz power lines. The
detection of power lines will not interfere
with the detection of ferrous metal objects.
VOL
VOL
Note: This feature is not intended to be
will
MODE
STANDARD
used to locate or pinpoint electrical power
ERASE
SMART
cables. If there is no current ow through
the power line, there will be no detection
indication even though the power line
may be energized. The distance from the
power line along with the current ow
through the power line determine the
detection range.
- 21 -
SENS VOL
SENS VOL
SENS VOL
MODE
SENS VOL
indicates North polarity
STANDARD
ERASE
SMART
MODE
indicates South polarity
STANDARD
ERASE
SMART
VOL SENS VOL
SENS VOL
South polarity. MODE
STANDARD
SMART
VOL
VOL
MODE
STANDARD
ERASE
SMART
VOL SENS VOL
SENS VOL
North MODE
STANDARD
ERASE
SMART
ERASE
VOL SENS
SENS
2a is
VOL
VOL