Citysports CS-WP3 Instructions page 12

When you use a walking machine, because the force of both feet is not the same when running,
the pressure on the running belt is unbalanced, causing the running belt to deviate from the
center. This deviation is normal, and when no one runs in the running, it returns to the center.
If you can't get back to the center, you'll need to bring the running belt back to the center.
1. Run the machine empty and set the speed to 6km/H.
2. Observe the distance from the run to the left and right bars.
If to the left, use a hex wrench and turn the left screw 1/4 turn clockwise

If to the right, use a hex wrench and turn the right screw 1/4 turn clockwise

If the running belt is still not in the middle, repeat the above action until adjusted to the middle

3.adjust the running to the middle, the speed to high speed, and observe the deviation of the
running belt and running smoothness, if there is a deviation, repeat the adjustment step.
4.If the above steps do not work, you need to tighten the running belt again.
Warning! Do not overtighten the drum! This will result in permanent damage to the bearings!
2.Walker and Oiling
The walker has been pre-added with lubricant before the factory. However, due to the friction
between the running belt and the running board has a great impact on the service life and
performance of the product, it is necessary to add lubricant according to the machine prompt.
Whenever the accumulated mileage of the walk-off machine reaches 50KM, the display will
appear red refueling to provide a display.
Refueling
Note: Please use treadmill-specific lubricants or contact our company directly.
Refueling Operation:
Cut the seal of the inner mouth of the oil bottle and cut the cap of the bottle open a small

mouth (can be smoothly squeezed out);
Turn the filling hole plug;

Turn the machine to 1KM speed, the bottle port is aimed at the fuel pipe hole to squeeze out

the right amount of oil, about 20 ml a time;
 After adding the silicone oil, the machine runs for about 3 minutes. After the silicone oil is
evenly distributed to the running belt, press the
the instrument) to stop, and then long press the remote control + button for 10 seconds
(or the keyboard simultaneously press the plus button and (Press and hold the speed 6 button
for 10 seconds) Cancel the refueling prompt icon.
Finished!
Https://www.LikeSporting.com
remote control button (or the button
- 10 -
ＥＮ
on