Introduction; Important Information; Installation & Operating Instructions; Ac Adapter - Acculab SVI Serie Manuel D'utilisation

ENGLISH

Introduction

Thank you for purchasing an Acculab SVI Series Professional Scale. Please read all of the operating
instructions to ensure optimum performance. The unit is pre-calibrated at the factory and is ready to use
with the supplied AC adapter.

Important Information

Allow 15 to 20 minutes warm up time before starting calibration routine in order to give internal
components sufficient time to stabilize.
Avoid lengthy exposure to extreme temperatures. Your scale works best when operated within the
temperature range listed within the specifications.
Place scale platform on solid, level surface.
Keep environment clean, avoid dust, dirt & liquids from getting inside of scale platform and indicator,
which can adversely effect and damage the scale.
Vibrations, air currents and electromagnetic interference may effect the performance of the scale.
Although the scale is very durable, please prevent excessive overloading and dropping objects on to
the platform that may cause permanent damage to the weight cells.
Installation & Operating Instructions
Remove and inspect all contents from package. If you will be mounting the indicator with the provided
bracket we suggest that you install this first (note: please do not remove cable from the base or indicator).

AC Adapter:

After setting-up the base and the indicator within the desired location plug (included) AC adapter into
main outlet (AC adapter voltage dependent upon local region / only use AC adapter provided with scale.
Use of another type of adapter may permanently damage the scale and void warranty). Turn unit on by
pressing the "ON/OFF" key. Self diagnostic test will automatically run displaying "8.8.8.8." and releasing
to weigh mode with selected unit (Example: "0.000kg"). Scale is ready for use. For additional features and
operation please see "Key Functions / Description" and "Features".

Battery Operation:

One 9 volt Alkaline or 9 volt NICAD rechargeable battery is required (not included with scale). To install
battery, open battery cover located on the back of the indicator. Connect battery to the leads accordingly
and install within holder and replace cover. It is recommended to remove battery when scale is not in use
for extended periods. Also replace low or dead batteries.
Note: Back-lit display is "off" unless activated with "LIGHT" key.
1
.