HI-Q TOOLS PM1100 Manuel D'utilisation page 9

CONTACTING POLO
Website: www.polo-motorrad.de
Email: info@polo-motorrad.com
Mailing Address: Polostr. 1
D-41363 Jüchen
ABOUT PM1100 Each process is uncomplicated and
easy to accomplish. The PM1100 is designed for charging
all types of 12V lead-acid and 12V lithium-ion batteries,
including Wet (Flooded), Gel, MF (Maintenance-Free), CA
(Calcium), EFB (Enhanced Flooded Battery), AGM (Ab-
sorption Glass Mat), and LIB (Lithium Ion) batteries. It
is suitable for charging battery capacities from 2 to 40
Amp-Hours and maintaining all battery sizes.
MOUNTING The PM1100 has two external holes for
mounting. Mount the charger in a desired location with
6 self-drill screws. Make sure there are no obstructions
behind the mounting surface. It is important to keep in
mind the distance to the battery. The DC cable length
from the charger, with either the battery clamp or eye-
let terminal connectors, is approximately 75-inches
(1,900mm).
CHARGING MODES The PM1100 has five modes: Stand-
by, 12V NORM, 12V COLD/AGM, 6V NORM, and 12V LITH-
IUM. Some charge modes must be pressed and held
for three seconds to enter the mode. These "Press and
Hold" modes are advanced charging modes that require
your full attention before selecting. "Press and Hold" are
indicated on the charger by a red line. It is important to
understand the differences and purpose of each charge
mode. Do not operate the charger until you confirm the
appropriate charge mode for your battery. Below is a
brief description:
Mode
In Standby mode, the charger is not
charging or providing any power to
the battery. Energy Save is activated
Standby
during this mode, drawing microscopic
power from the electrical outlet. When
selected, an orange LED will illuminate.
No Power
For charging 12-volt Wet Cell, Gel Cell,
12V
Enhanced Flooded, Maintenance-Free
NORM
and Calcium batteries. When selected,
a white LED will illuminate.
14.5V | 1.1A | 2-40Ah Batteries
For charging 12-volt batteries in cold
12V
temperatures below 50ºF (10ºC) or
COLD/
AGM batteries. When selected, a blue
AGM
LED will illuminate.
14.8V | 1.1A | 2-40Ah Batteries
For charging 6-volt Wet Cell, Gel Cell,
Enhanced Flooded, Maintenance-Free
6V
and Calcium batteries. When selected,
NORM
a white LED will illuminate.
7.25V | 1.1A | 2-40Ah Batteries
Press & Hold
For charging 12-volt lithium-ion bat-
teries, including lithium iron phos-
12V
phate. When selected, a blue LED will
LITHIUM
illuminate.
14.2V | 1.1A | 2-40Ah Batteries
Press & Hold
Explanation
17