HI-Q TOOLS PM1100 Manuel D'utilisation page 11

UNDERSTANDING CHARGE LEDS
The charger has four Charge LEDs - 25%, 50%, 75%
and 100%. These Charge LEDs indicate the connected
battery(s) state-of-charge (SOC). See the explanation
below:
LED Explanation
25% The 25% Charge LED will slowly pulse
Red LED "on" and "off", when the battery is less
than 25% fully charged. When the bat-
tery is 25% charged, the red Charge LED
25% 50% 75% 100%
will be solid.
50% The 50% Charge LED will slowly pulse
Red LED "on" and "off", when the battery is less
than 50% fully charged. When the bat-
tery is 50% charged, the red Charge LED
25% 50% 75% 100%
will be solid.
75% The 75% Charge LED will slowly pulse "on"
Orange LED and "off", when the battery is less than
75% fully charged. When the battery is
75% charged, the orange Charge LED will
25% 50% 75% 100%
be solid.
100% The 100% Charge LED will slowly pulse
Green LED "on" and "off", when the battery is less
than 100% fully charged. When the bat-
tery is fully charged, the green LED will
25% 50% 75% 100% be solid, and the 25%, 50% and 75%
Charge LEDs will turn "off".
Mainte- During maintenance charging, the 100%
nance Charge LED will pulse "on" and "off" slowly.
Green LED When the battery is topped off and fully
charged again, the 100% Charge LED will
turn solid green. The charger can be left
25% 50% 75% 100%
connected to the battery indefinitely.
UNDERSTANDING ADVANCED DIAGNOSTICS
Advanced Diagnostics is used when displaying Error
Conditions. It will display a series of blink sequences
that help you identify the cause of the error and po-
tential solutions.
All Error Conditions are displayed with the Error
LED and Standby LED flashing back and forth. The
number of flashes between each pulse denotes a po-
tential Error Condition (except reverse polarity and
low-voltage battery).
Error
Battery will not hold a charge.
Single
Have battery checked by a
Flash
professional.
Possible battery short.
Double
Have battery checked by a
Flash
professional.
Battery voltage is too high for
Triple
the selected charge mode.
Flash
Check the battery and charge
mode.
Error LED Reverse polarity. Reverse the
Solid Red battery connections.
Battery voltage is too low for
Standby charge to detect or charger is in
Solid Orange supply. Jumpstart the battery to
raise the battery voltage.
Reason/Solution
21