Publicité
Les langues disponibles
Les langues disponibles
Set Anti-Collision Sensitivity
Your adjustable LIFT desk is equipped with an anti-collision feature to prevent the risk of injury
and/or damage to objects in the path of the moving table. When movement is interrupted, the desk will
automatically stop and briefly move in the opposite direction. Set the level of sensitivity that is correct
for your environment. It is recommended that you begin with A3 and reduce sensitivity as needed. To
cycle through A0-A1-A2-A3: Press and hold the up "
time and release.
"A0" = Anti-collision is OFF.
"A1" = Sensitivity is LOW.
"A2" = Sensitivity is MEDIUM.
"A3" = Sensitivity is HIGH.
Reset
a. Press and hold "M" and "3" simultaneously, until the display reads: "ASR" and the signal
sounds.
b. Press and hold " " until the device has completely lowered and the display reads: "60.0".
All saved positions will be lost.
Troubleshooting
a. If the desk is moving very slowly up or down, it is most likely over-loaded. Max weight:
125kg. Frequently using the device at full capacity may reduce its lifespan. If the device is
not over-loaded, check that the power source is connected and capable of delivering AC
110-240V, 50/60Hz, 15A.
3
" and down "
" buttons for 5s at the same
47.96.60.v3_117014-1
Publicité
