Grinding; Maintenance; Maintenance And Servicing Plan - HOLZMANN MASCHINEN DSM150 Manuel D'instructions

15.3.3 Grinding

Grinding is a science for itself! Different metal alloys, profile types, the correct grinding angle
as well as the material and grain of the grinding disc and the grinding speed have a decisive
impact on grinding results. Each steel type requires an optimized grinding stone for best results.
As a rough rule of thumb, single and multiply alloyed steel can be grinded with aluminium oxide
grinding stones with granularity K 80.
For grinding the blades of axes, pickaxes, spades etc. an aluminium oxide stone with granularity
40-60 can be sufficient.
16 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. For this reason, always disconnect the machine
from the power supply before cleaning, servicing or maintenance work and secure it
against accidental start-up!
16.1 Cleaning
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Keep the surfaces and ventilation slots of the machine free of dust and dirt. For cleaning, use a
soft cloth and a mild soap solution and, if necessary, a damp-free jet of compressed air.
16.2

Maintenance

The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
 Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
 Only use perfect and suitable tools.
 Only use original spare parts recommended by the manufacturer.

16.2.1 Maintenance and Servicing Plan

The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when using the machine within the specified limits:
Interval
Before every start of work
Each time after completion
of work
As required
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
W A R N I N G
N O T I C E
Component
grinding disc
power cord
surfaces
grinding wheel
www.holzmann-maschinen.at
What to do?
check for damage
remove dust and dirt
replace
DSM150, DSM175, DSM200, DSM250
24