Télécharger Imprimer la page

Kalorik STP 30138 Mode D'emploi page 9

Publicité

Les langues disponibles

Les langues disponibles

Fax +32 2 359 95 50
Loosely wrap the electric cord and place it in the opening at the
front of the base of the ironing board. You can also disconnect
the power cord from the unit.
Emptying the water tank after each use is preferable if possible.
CLEANING
To clean the pressing plate, place the pressing cushion in the
center of the ironing board. Place a clean towel over the
pressing cushion and the ironing board. Set the temperature
control to its maximum setting. When the ready light comes on
and the steam ready light goes off, gently lower the pressing
plate onto the pressing cushion. With water in the water tank,
press the burst of steam button 6 to 7 times. Be careful to avoid
touching the hot metal surfaces or leaving your hand in the way
of steam.
Once the pressing plate has cooled down you can clean the
surface with a damp cloth. DO NOT use any abrasive material or
cleaner on the pressing plate! This pressing plate has a non-stick
coating that will help for cleaning.
The ironing board cover is removable for normal washing. You
can clean the ironing board cover with water and mild
detergent; rinse with warm water.
SAFETY FEATURES (AUTO SHUT-OFF)
The multiple safety features of this appliance turn off electric power
to the heater when the pressing plate has been left against the
ironing board for about 10 seconds. You will hear a warning beep
and the red power indicator (7) will start flashing. If the pressing plate
(2) is left in the open (up) position without use after approximately 15
minutes, the unit will also be automatically shut-off.
In either case, to restart the unit, you have to press the "ON/OFF"
button (8) again.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
9
Assembly page 9/35
special
instruction
from
Team
Print only
STP 30138 - 120501

Publicité

loading