Publicité
Exemple de raccordement :
Mélangeur
Séparateur actif X-Over 80
Amplificateur
des basses
Raccordement de la table de mixage ou de l'amplificateur
Raccordez la sortie gauche de la source
audio (table de mixage etc.) avec l'en-
trée CH1 INPUT.
Raccordez la sortie droite de la source
audio (table de mixage etc.) avec l'en-
trée CH2 INPUT.
Raccordez les sorties du séparateur
actif
avec
les
entrées
de
votre
amplificateur.
34
Amplificateur
des sons moyens
et aigus
Le séparateur X-Over 80 est équipé de
prises/connecteurs XLR symétriques et
de prises cinch asymétriques. Le choix
des branchements n´est pas important
pour le fonctionnement N´utilisez toute-
fois qu´un seul type de connexion.
Sortie SUB = Amplificateur des basses
Sortie SAT = Amplificateur des sons moy-
ens et aigus
Mains connection
The power source for the appliance can either be 230VAC / 50Hz
(e.g. for Germany) or 115VAC / 60Hz . Additionally, on the rear side
is a voltage selector switch for 230VAC and 115VAC. Make sure
that the voltage selected corresponds to that of the appliance to
which it is connected. You may otherwise destroy the appliance.
First of all connect the supplied power cable to the appliance. Only then should you
connect the mains plug to a mains socket linked to the power supply network.
Operation
Detailed description of control functions:
LEVEL MAIN-control (2)
This sets the output levels for SUB OUT- and the SAT
OUT-outputs
Turning it to the left reduces the output level and to
the right increases it.
LEVEL SUB-control (3)
This adjusts only the SUB OUT-signal.
Use this control to set the relationship between the
SUB-signal and the SAT-signal.
SUB LEVEL-monitor (4)
The SUB LEVEL-meter allows you to keep an eye on
the SUB-output levels.
Avoid distortion by maintaining the LED light meter
below the white peak level.
FREQ SUB-control (5)
Used to set the SUB OUT-output cutoff frequency.
The cutoff frequency can be set infinitely variable wit-
hin a range of 50 Hz – 200 Hz.
PHASE SUB-switch (6)
Switch-over the SUB output phase.
This will solve any phasing problems.
0° setting:
Normal phase
180° setting :
Phase rotated 180°
FREQ SAT-control (7)
Used to set the SAT OUT-output cutoff frequency.
The cutoff frequency can be set infinitely variable wit-
hin a range of 50 Hz – 200 Hz.
23
Publicité
Chapitres
Dépannage
