Digigram IQOYA TALK Mode D'emploi page 2

ENGLISH
CONTENTS OF THIS PACKAGE
The package consists of the fol-
lowing components:
• An IQOYA TALK device
• One Lithium/Ion battery
• One external power supply with
cable
• Four cellular antennas
• One WiFi / Bluetooth antenna
• One USB C cable
• One External battery charger
NETWORK/AUDIO INTERFACE
SETUP
Before starting the device, prepare
the network and audio interfaces.
You can choose between LAN or
3G/4G.
Ethernet:
Connect Ethernet cable(s) to the
Eth.1 and/or Eth.2 port.
Cellular module(s):
1. Insert the SIM Tray Ejector into
the small hole on the SIM card-
holder. Press the ejector firmly
into the hole to push the SIM
card tray out.
2. Carefully pull the SIM card tray
out of the slot and place the
1
SIM card correctly.
3. Plug the SIM card tray back
into your device.
Antennas:
IQOYA TALK comes with 5 anten-
nas (4 cellular and 1 WiFi). Care-
fully connect them to the respec-
tive ports if needed.
Microphones:
IQOYA TALK can accommodate
three external microphones. The
microphone XLR ports are placed
on the front side of the device.
Headphones:
The IQOYA TALK can accom-
modate up to four headphones.
Section 3 has two separated
headphone ports (meant to be
shared by two guests).
STARTING UP:
The IQOYA TALK can be powered
by an external power supply or by
internal batteries.
To start the device:
1. Connect the power cable to the
4 PIN DIN port on the back of
the device and press the on/off
power button.
Or
2. Unscrew the battery 1 compart-
ment lid on the left side of the
device and insert the battery.
Once the battery 1 compart-
ment is closed, press the on/off
power button. If you have pur-
chased an additional battery,
then follow the same process
to insert the second battery into
the Battery 2 compartment on
the right side of the device.
FIRST CALL CONFIGURATION:
It is possible to interact with IQOYA
TALK using just the touch screen
or by using the physical buttons
and rotary knobs. Follow the 4
Steps given below to make the first
call using IQOYA TALK.
Step 1: Click on the Connections
button:
This button contains three tabs - IP
STREAM, SIP and NETWORK.
IP STREAM:
1. If required, this tab allows you
to modify PROGRAM
TALKBACK settings.
SIP:
Select between "PGM" (Program)
or "TB" (Talkback) for the respec-
tive SIP accounts. Enter all the
mandatory information to the re-
gistration menu and press "APPLY
& REGISTER" to configure the ac-
count.
NETWORK:
1. ETH 1 and 2: Edit/configure
the IP parameters individual-
ly or simply toggle the DHCP
option to "Yes" to automatically
configure the network settings.
Press the "Apply" button to
save any changes.
2. CELL 1 and 2:
sub-tabs can only be accessed
if there are any sim-card(s)
inserted. To activate the sim-
card, toggle the "Active" option
to "YES" and enter the "Access
Point Name (APN)". Press "AP-
PLY" to complete the activation.
Once all the steps are completed
properly, there will be 2 green
PGM and TB icons on the main
notification header. This indi-
cates that connection settings
and have been entered correctly.
These two
2