Heitronic Infinity Instructions D'installation Et De Maintenance page 10

H. Vollmer GmbH
GB Installation and operating instructions
LED Spotlight
Art. No. 23176, 23177, 23178, 23179, 23180, 23181
These operating instructions apply exclusively to this product.
They contain important instructions for commissioning and handling the LED-Spotlight.
Please therefore follow these operating instructions, even if you pass this product on to third
parties.
It is important for this reason that you keep these instructions in a safe place for future reference.
1. Introduction
Dear Customer,
Many thanks for deciding to buy our product.
You have obtained a product from the Vollmer Company and this product has been manufactured in
compliance with the state of the art technology.
The LED-Spotlight meets the requirements of the European and national directives currently in force.
As a user, you must follow these operating instructions to maintain the condition of the product and to
operate it safely!
2. Safety notes

Damage caused by non-compliance with these operating instructions, invalidates all warranty claims!

We undertake no liability for consequent damages!

Commissioning the LED-Spotlight is strictly forbidden if there is damage.

Never let children play unattended near the LED-Spotlight or other electrical devices.

Do not expose the LED-Spotlight to extreme heat or open flames.

The built-in spotlight must not be covered under any circumstances whatsoever with thermally
insulating coverings or similar materials.

The entire product must not be converted or modified. Changes if made to the LED-Spotlight shall
invalidate the warranty.

The rating plate must not be removed.
3. Intended Use
The LED Spotlight is designed for indoor use in dry and protected conditions.
This product is only intended for lighting purposes and may:

only be operated with a voltage of 230V ~50Hz.

only be connected in compliance with the protection class II (two).

only be operated when it is firmly attached to a stable, level and tilt-free base.

only be operated on normal or non-inflammable surfaces.

not be exposed to strong mechanical loads or large amounts of dirt.
4. Before installation/commissioning

The LED-Spotlight may only be operated after removing the packaging.

Take the LED-Spotlight carefully out of the packaging.

Before commissioning the LED-Spotlight make sure that it has not been damaged in transit. The LED-
Spotlight must not be operated if the electrical components have been damaged. Repairs may only be
undertaken by a specialist electrician.

Keep the packaging material well away from children and household pets. Danger of suffocation!
Installation instructions Art. No: 23176, 23177, 23178, 23179, 23180, 23181, Page 1 of 3
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach Stein
Status 20.11.2018