Axis P1311 Mode D'emploi page 5

AXIS P1311 Installation Guide
Install the hardware
!
IMPORTANT! - The casing of the AXIS P1311 is not approved for outdoor use - the
product may only be installed in indoor environments.
Connect the cables
1. Connect the camera to the network using a shielded network cable.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 6 for information
on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect power, using one of the methods listed below:
• The supplied power connector.
• PoE (Power over Ethernet). If available, this is automatically detected when the network
cable is connected (see above).
5. Check that the indicator LEDs indicate the correct conditions. See the table on page 16 for
further details. Note that some LEDs can be disabled and may be unlit.
Page 5